I never know what to do with the giblets that come with the turkey. I usually just toss them in the garbage, but this year I figured I wouldn’t waste anything and decided to make some dog treats. My dogs loved them, so hopefully yours will too.
Recipe: Skill Level=Easy
Food processor or blender
Cookie Sheet (preferably stone, but any kind will work)
Cookie Cutter (I used a bone shape, but any shape will work)
1 cup cooked turkey giblets (I boiled mine in chicken broth, but you can cook them anyway you like)
2 large carrots, peeled and cooked (boil in water until tender)
3/4 cup unsalted chicken stock
1 cup rolled oats
2/3 cup Bob’s Red Mill Gluten Free Corn Bread Mix
1 organic egg
Preheat oven to 250 degrees Fahrenheit
Blend giblets and half of the chicken stock in the food processor until a paste forms.
Add oats and remaining chicken stock and blend.
Transfer into a bowl.
Add egg, cornbread mix and carrots and fold with rubber scraper until a nice dough forms in the bowl.
Dust your surface and rolling pin with some of the cornbread mix leftover in the bag.
Dust the top of your dough ball with some cornbread mix and roll dough out into 1/4″. Dust your cookie cutter with the cornbread mix and cut out biscuits with the cookie cutter and place on parchment lined cookie sheet.
It was September 17th, and I was ready for Halloween. I figured I should put some of my Michael’s coupons to use and start my first Halloween project. I have always loved when Disneyland transforms the Haunted Mansion for Halloween and Christmas, so I decided to attempt to make the wreath from the ride. I figured I could use it on both Halloween and Christmas (Self justifying my purchases, because I may have a bit of a crafting hoard already).
I do not consider myself an artist in the slightest. I consider myself “crafty”. This project is definitely a crafty project. As long as you can paint some circles, you will do just fine!
Step 1: Cut 1 larger egg and 3 smaller eggs in half. Paint both sides of larger egg yellow, and 1 side of each of the smaller 3 eggs yellow and set aside to dry. Paint the other side of the smaller 3 eggs green and set aside to dry.
Step 2: While the painted eggs are drying, cut pieces of holly and find a center place for the “nose holly”. Glue holly for nose and additional holly where you desire. Cut stems off of red sunflowers and glue them on the bottom portion of the wreath.
Step 3: Cut teeth from Foam Board using X-Acto knife. These don’t need to be done in any specific fashion. I just cut random fangs. Once cut, glue to the back of the wreath, and reinforce the hold with a piece of the foam sheet. I cut 14 teeth total. 7 for the top and 7 for the bottom.
Step 4: Once the yellow paint has dried, paint the black dots on the large eggs for the pupils and set aside to dry. Paint the inside of the smaller eggs red, and set aside to dry. Mix yellow and red paint together to make the color to use for the mini monster’s lips. Use that paint to paint a strip of the foam sheet and set aside to dry.
Step 5: Once the paint has dried on all pieces, take the green side of the mini-monster mouths and paint yellow and red dots on them and set aside to dry.
Step 6: While the paint is drying on the dots you may now cut thin strips of the foam sheet you painted and begin gluing it to the yellow part of the mouths. Also cut small pieces of the foam sheet into teeth for the mini-monsters (about 1/4″ or more big) and set aside).
Step 7: Once the paint has dried on the dots, begin attaching the foam sheet teeth to the bottom portion of you mini-monster mouth and lips(to bottom and top) with your glue gun. Then glue the 2 sides of the of the mouths together and reinforce the hold with an additional piece of foam (pictured on the left).
Step 7: Glue on the large yellow eyes, mini-monster mouths and monster wiggle eyes.
Step 8: Once the glue has cooled, tie the black and white ribbon into a bow on the bottom of the wreath. (I actually tied the bow around a piece of the wreath). Attach arms by using the the wired pine garland ties. Simply twist and attach to make arms.
If you make one of these, please comment and let me know how it turned out.
I was watching Season 4 of Scandal and suddenly became inspired by the character Harmony to make soap using animal fat. I have made soap for a few years using all plant based oils, but I have been wanting to try something new. On Saturday while frying bacon, I decided I would give it a try. I always strain my bacon grease into a coffee mug, but this time I strained it through a cheesecloth to remove any residual meat flakes. I then weighed the grease and grabbed some of my other oils and got my creative hat on.
I figured since I am using bacon grease, this was definitely a soap I would make as a gift for the men in my family. I mean, what man doesn’t love bacon? I then asked my husband to help me pick out a fragrance and we decided on Sensuous Sandalwood from Brambleberry. Once the scent was determined, I chose my additional oils to incorporate. I didn’t have enough bacon grease to complete a whole batch of soap made with just bacon grease alone.
Once I determined my oils and their weights, I went back onto Brambleberry’s site to utilize their lye calculator. The calculator asked for a superfatting level, and I wasn’t quite sure what that meant. I have always made my soap from recipes where I was already given the lye amount, so superfatting levels were new to me. I found this article that helped it explain it to me and I chose a level of 3%. Once I had my lye and liquid calculation figured out, it was time to get to work.
****If you have never made cold process soap before, please make sure to read all guidelines and safety precautions before starting this recipe. Lye is reactive and can burn.****
Soap made with Bacon Grease
3.5 oz Bacon Grease (Strained through a cheesecloth to remove any meat particles)
Weigh all oils and combine them in one bowl to melt down. (I like to use a small crock-pot for this.)
Weigh and measure water and lye in SEPARATE glass bowls. (I use 2 Pyrex glass bowls.)
Begin adding lye to the water a little a time and stirring. You will notice the water getting cloudy. Keep adding the lye and stirring until all flakes have dissipated.
Begin warming your oils in your crock-pot or in the microwave while the lye water is cloudy.
Once your oils have melted and the lye/water is clear again, take their temperature. You want both to be in a range from 120-140 degrees Fahrenheit.
Once both the lye/water and oils are around the same temperate, it is now time to add the lye/water to the oil.
Grab your stick blender, and slowly pour the lye/water over the stick blender into the oils. (If using a crock-pot, turn it off. You do not need to warm the oils anymore).
Once lye/water and oils are in the same bowl, tap the stick blender on the bottom on the bowl to release any air bubbles.
Turn the stick blender on to high and begin mixing. Soaponification will occur within about 1-2 minutes. You will notice a trace forming. (This recipe thickened pretty quick, looking very much like pudding.)
Once trace has occurred, add the fragrance oil and mix again to incorporate the fragrance throughout.
Pour soap into your mold and cover and let sit for 24-28 hours. (I let mine sit for 48 hours). I keep my soap covered by using a wooden champagne box.
After 24-48 hours, un-mold your soap and cut into bars. Once cut, let cure for 4-6 weeks. (I place mine on a baking rack in my guest room to cure.)
Enjoy! I would love to hear your comments if you make this recipe. You may also contact me if you would like to order some of these already made.
I recently came to the conclusion that I may have a serious candle addiction. Every time I pass candles in any store I must stop and smell all of them. This usually leads to the purchase of more candles that I don’t really need, but can’t live without.
As I was organizing my containers for body butters, I noticed I had extra glass jars that I no longer use for my body butters. I just couldn’t bring myself to just toss them in the recycle bin, so I grabbed my beeswax and got to work. I was able to feed my candle addiction, but by using items I already had around the house.
Palm Oil (50%)
Essential Oils. Any scent except Sweet Orange. The scent evaporates when burned so it’s pointless to add. (For this batch of candles, I used Lemongrass and Peppermint)
Glass Jars with a screw on lid (I used small 4 oz craft jars that I purchased from the dollar section at Target)
Candle Wick (Generally for beeswax candles, you want to use a cotton wick. I purchased mine from Amazon.)
Wooden BBQ skewers
A pouring ladle (I used a stainless steel Weight Watcher’s 1/4 cup ladle)
Prime the candle wick: Melt beeswax (enough for how much wick you’ll be using) in your double boiler. Once melted, place wick in beeswax and wait until all bubbles from wick stop. Remove wick from the wax and lay flat on a wax proof surface (my granite counter top was just fine to use) and allow to dry (about 10-15 minutes). Once dry, cut your wick according to your jar size, but allow an extra 2-3 inches to wrap around the skewer.
Figure out how many candles you are going to make. For example, if you are just making one 4 oz jar candle, you will need to melt down 2 oz of beeswax and 2 oz of palm oil. To make beeswax candles, you want to always use a measurement of 50/50 beeswax & palm oil.
Melt beeswax and palm oil in double boiler on medium heat as shown below. Mix often with the wooden skewer.
4. Once beeswax and palm oil has melted completely, add essential oils. For one 4 oz candle I used 7 drops lemongrass and 3 drops peppermint. I usually will just add, mix, and smell. If it isn’t strong enough to my liking, I will add more.
5. Pour about 1/2 inch of wax mix into the bottom on the jar using the ladle. Place candle wick in the center and hold in place until it wick stands on it’s own. (You can avoid the holding step if you get candle wick tabs, but I didn’t have any on hand).
6. Once the wick stands on it’s own, wrap the top of the wick around a wooden skewer to hold it in place and set aside until all 1/2 inch of wax has cooled. (Touch the bottom of the glass jar, if it still feels warm, wait longer. I made that mistake and my wick came loose when I poured the rest of the wax).
7. Once the 1/2 inch of wax has completely cooled, pour the remaining wax into the jar using the ladle. After the wax settles a bit there may be an air bubble hole left. Pour additional wax into the jar to cover hole.
8. Allow candles to sit 12-24 hours before use. Trim excess wick leaving 1/4-1/2 inch, screw on lid to jar and enjoy!
Who doesn’t love something for free? I would like to offer you my toner recipe that I use daily. It’s simple to make and works wonderfully for my acne-prone skin.
3 oz travel spray bottle
rosemary essential oil
melaleuca (tea tree) essential oil
Directions: Fill spray bottle almost full with distilled water and leave about 1/2 inch at top of the bottle. Place 10 drops rosemary essential oil and 10 drops melaleuca essential oil, screw on cap and shake to mix.
Make sure to shake the bottle before each application. You can either spray the mist directly on your freshly washed face, or spray some on a cotton pad and use like a bottled toner.